product description

Dimonon UV-Curing Glue DML4115 is a single component, a thixotropic high viscosity, an ultraviolet curing adhesive, and a transparency can be formed between the substrate in a few seconds under the ultraviolet irradiation of a certain wavelength. Ok, you can't see any glue layer bonding. Excellent impact resistance is suitable for bonding of most materials.

Typical use typical application

For metal, glass, electronic components, bonding fixation of plastic classes.

Curing before curing

Typical range

Exterior transparent liquid

Betting chemical ingredient acrylate

Viscosity (MPA.s) 3800 ~ 6000

Density (g / cm3) 1.10- 1.13

(GB/T 13354- 1992)

Curing condition

Curing using 40MW / cm2 ultraviolet rays

Surface abbreviation time (s) 10

Curing depth (mm @ 30s,) 3.0

Curing after curing

Typical range

Hardness (Shao D) 65

(GB/T2411- 1980)

Tensile strength (MPa) 20

(GB/T1040- 1992)

Fracture elongation (%) 180

(GB/T1040- 1992)

Shear strength (MPA, spray steel / glass) 12

(ASTMD 4501-2001)

Work temperature (° C) -50- 150

Electrical performance

Dielectric constant (1MHz) 5.2

(GB/T1409-2006)

Dielectric loss (1MHz) 0.03

(GB/T1409-2006)

Dielectric intensity (kv / mm) 25

(GB/T1408.1- 1999)

Volume resistivity (ω.cm) 8 × 1012

(GB/T1410-2006)

Instructions for use

1. The rubber site should be removed and clean.

2. Apply the rubber to the portion of the glue, irradiated with a 365 nm wavelength of ultraviolet lamp, confirming that the ultraviolet line can be permeated to the bonded portion.

3. The curing speed of this product depends on the intensity of the ultraviolet rays, the depth of the desired curing of the light source and the gum layer.

4. After using the item, you must cover the cover immediately.

5. This product must be packaged in black or other dark hose.

Precautions

1. Stay away from children.

2. Do not reap back into the original packaging to avoid contaminating. This product contains methacrylate and has stimulating skin eye.

3. If you don't touch your eyes and skin, flush it with water and go to the hospital for examination.

4. When the customer storage temperature is lower than 20 ° C, in order to ensure the use of the effect, the customer uses it back at 25 ° C for 24 hours before use.